一般项目
General items
1）涂料防水层的基层应牢固，基面应洁净、平整，不得有空鼓、松动、起砂和脱皮现象；基层阴阳角处应做成圆弧形。
1) The base of the coating waterproof layer should be firm, the base surface should be clean and flat, and there should be no empty drum, loosening, sand and peeling phenomenon; the base should be made into a circular arc at the Yin and Yang corners.
检验方法：观察检查和检查隐蔽工程验收记录。
Inspection method: Observe and inspect the acceptance records of concealed projects.
2）涂料防水层应与基层粘结牢固，表面平整、涂刷均匀，不得有流淌、皱折、翘边、鼓泡、露胎体和翘边等缺陷。
2) The waterproofing layer of the coating should be firmly bonded with the base layer, with a flat surface and uniform brushing. No defects such as flow, wrinkle, warping, bubbling, exposed body and warping are allowed.
检验方法：观察检查。
Methods: Observation and examination.
3）涂料防水层的平均厚度应符合设计要求，最小厚度不得小于设计厚度的80%。
3) The average thickness of waterproof coating should meet the design requirements, and the minimum thickness should not be less than 80% of the design thickness.
检验方法：针测法或割取20mm×20mm实样用卡尺测量。
Inspection method: Needle test or cutting 20 mm *20 mm solid sample to measure with caliper.
4）侧墙涂料防水层的保护层与防水层粘结牢固，结合紧密，厚度均匀一致。
4) The protective layer and waterproof layer of side wall coating are firmly bonded, tightly bonded and uniformly thick.